User's Manual

RELEASED INTERNAL USE ONLY
RELEASED INTERNAL USE ONLY
Remote Antenna Fixed Phone Rework Instructions Converting the fixed phone Radio Antenna Unit (RAU)
80-99438-1EN Rev. - 3
2. Remove the four screws holding the interface CCA in place and slowly lift
the interface CCA straight up until it is removed from the pins on the
connector under the CCA.
Figure 3. RAU with interface CCA removed
3. Unscrew the 11 Phillips head screws, holding the top housing of the RAU
in place, and slowly tilt the top housing to the right, being careful not to
jerk the two cables between the CCA on the cover and the CCA in the
unit.
Figure 4. RAU with top housing tilted
4. Disconnect the yellow flex ribbon cable by unlocking J1. Disconnect the
black and white wire from J5.