User's Manual

RELEASED INTERNAL USE ONLY
RELEASED INTERNAL USE ONLY
Modifying your fixed phone antenna Remote Antenna Fixed Phone Rework Instructions
10 80-99438-1EN Rev. -
Note
Follow Section 3.1 if you are using the quadrifilar helix antenna for
your installation; otherwise go to Section 4.0 if you are using the
dome shaped antenna.
3.1 Converting the antenna from OSX connectors to SMA
connectors
3.1.1 Before you begin
Before you start the conversion, be sure to mark the transmission (Tx) cable on
the antenna with a paper tag or in some way so that you will know it is the Tx
cable later. This way you will not mix up the cables when changing the
connectors. You will need the following parts for the conversion:
• Shrink tubing
• 2 ferrules
• 2pins
• 2 SMA female connectors
• Tools to strip the wire and crimp the pin and ferrules
Wire
Teflon wire
covering
Coaxial
mesh
Cable
insulation
Ferrule
Shrink
tubing
304AA_01
Figure 16. Wire stripped