User's Manual

RELEASED INTERNAL USE ONLY
RELEASED INTERNAL USE ONLY
Remote Antenna Fixed Phone Rework Instructions Modifying your fixed phone antenna
80-99438-1EN Rev. - 11
315AA_01
Brass connector Pin
Shrink tubing
Ferrule
Figure 17. Parts needed for conversion
3.2 Changing connectors
You will be changing the two existing OSX connectors to two identical female
SMA connectors.
1. Start by snipping off the connectors on the ends of both wires coming from
the antenna. Make sure that both wires are the same length.
2. Once the connectors are snipped off, slip the shrink tubing on each end a
little beyond the end of the wire.
Shrink tubing
305AA_01
Figure 18. Shrink tubing
3. Take two ferrules out of the package and slip one over the end of each
cable.
Ferrule
306AA_01
Figure 19. Ferrule