User's Manual

RELEASED INTERNAL USE ONLY
RELEASED INTERNAL USE ONLY
Modifying your fixed phone antenna Remote Antenna Fixed Phone Rework Instructions
12 80-99438-1EN Rev. -
4. Before you strip off the insulation jacket on each wire, adjust the wire-
stripping tool for the size of the wire so that the wire won’t be damaged or
nicked.
5. Turn the tool just once so you don’t cut through or nick the wire. Strip off
the insulation jacket.
Strip coax
307AA_01
Figure 20. Insulation jacket stripped off
6. Flare the ends of the coaxial cable shield.
Flair coax
308AA_01
Figure 21. Ends of coax flared
7. StripofftheTefloninsidetogettothewire.
Strip teflon
309AA_01
Figure 22. Teflon stripped off
8. Put the pin that goes inside the barrel of the connector over the wire ¼ of
an inch from the coax shield. Be sure that you can see the wire in the hole
of the pin.