User's Manual

RELEASED INTERNAL USE ONLY
RELEASED INTERNAL USE ONLY
Remote Antenna Fixed Phone Rework Instructions Modifying your fixed phone antenna
80-99438-1EN Rev. - 13
Pin
Crimp
310AA_01
Figure 23. Pin over wire
9. Adjust the crimping tool so it makes a proper crimp. If you are using the
amp crimp tool, set the tool to number three.
10. Insert the pin in the middle of the crimping tool. Crimp the pin close to its
bottom.
11. Take the female connector and push it until you can see the end of the pin
in the center hole of the plastic part of the connector. Push down the coax
shield over the base of the connector.
Brass
connector
311AA_01
Figure 24. Female connector on and showing pin inside connector
12. Adjust the ferrule-crimping tool to ferrule size and put tool on “A” side to
crimp the ferrule.
13. Slide the ferrule up to the connector.
14. Check the connector before crimping the ferrule because you can’t move
the ferrule after you crimp it.
15. Crimp the ferrule in place.