User's Manual

RELEASED INTERNAL USE ONLY
RELEASED INTERNAL USE ONLY
Remote Antenna Fixed Phone Rework Instructions Hooking up your Remote Antenna Fixed Phone
80-99438-1EN Rev. - 19
Figure 30. Dome-shaped antenna
2. Measure the distance between the RAU and the dome-shaped antenna
and select the appropriate cable type and length from the chart. See
Table 3-2.
3. Screw the SMA connector on one end of the cable to the Tx SMA connector
on the top of the brass plug on the RAU.
4. Screw the SMA connector on the other end of the cable to the Tx SMA
connector on the end of the Tx cable coming out of the dome shaped
antenna.
5. Repeat steps 3 and 4 for the Rx connection.
6. Dress and tie down your cables.
7. Apply power to and test your unit per the instructions in the installation
guide.