User Instructions

80-11139-4 Rev. AD MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 22
12 Required Regulatory Wording for User
Manual/Installation Manual
The integrator must include text in the user manual meeting the regulators requirements. The text
in the following sections or similar wording should be used.
NOTE: Text in red font must be replaced.
12.1 FCC compliance information
FCC compliance information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This product does not contain any user serviceable components. Any unauthorized product changes or
modifications will invalidate warranty and all applicable regulatory certifications and approvals, including
authority to operate this device.
FCC Part 15 Digital Emissions Compliance
We [System Manufacturer Name, Address, Telephone], declare under our sole responsibility that
the product [System Name] complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
WARNING: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates and radiates radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from the one the receiver
is connected to.
■ Consult the dealer or an experienced radio/TV technician for help.
The user may find the following booklet prepared by the Federal Communications Commission helpful:
The Interference Handbook
This booklet is available from the U.S. Government Printing Office, Washington, D.C. 20402. Stock
No.004-000-00345-4.