User Instructions

80-11139-4 Rev. AD MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 9
4 Integrated Product Test and Certification
Requirements
Integrators must adhere to test guidance provided in FCC KDB 996369 D04 available at this
website: https://apps.fcc.gov/oetcf/kdb/forms/FTSSearchResultPage.cfm?switch=P&id=44637
1. The module has been approved for the rule parts defined in Table 4-1. Host device must be
tested for Part15B compliance.
2. Radiated emissions testing should be tested per KDB 996369 with all transmitters active and
transmitting at max transmit power. A Qualcomm account representative can assist with
making test tools available as needed.
3. The recommended method of test is to use a call box simulator for WWAN where the UE is
configured for maximum transmit power. For WLAN testing, if an access point is not
available for mission mode testing, Qualcomm test tools can be used to configure the WLAN
modem for maximum transmit power and the desired mode/frequency of operation.
4. If a memory variant is utilized, limited WWAN and Wi-Fi transmitter testing should be
completed to ensure equivalent compliance. The following testing must be completed at a
minimum
□ Limited Unlicensed band edge measurement and unwanted radiated spurious emissions.
□ Radiated emissions in FCC Part 15.205 restricted bands during Wi-Fi and BT operation
□ Limited WWAN radiated emissions
□ Part 15B testing
□ Note: Data can be leveraged from the part of Part 15B and radiated emissions referenced
above to address continued compliance with the variant memory
5. RF Exposure must be addressed at the host level for all “portable” products where users are
less than 20cm from the device during normal operation (i.e. SAR testing is required) in
accordance with FCC KDB 447498. Host product manufactures must provide all required
documentation to the end user.
6. Antennas must follow the guidelines defined in Section 7
7. In the US, either a Class II Permissive Change or new equipment authorization is required.
Data can be leveraged from FCC ID:J9CQSIP7180 or FCC ID:J9CQSIP7180P per FCC KDB
484596