Owner's manual

Prior to use, read and understand all manufacturer’s instructions provided with equipment at time
of shipment.
Compliant with all OSHA 1910, OSHA 1926 Subpart M, ANSI Z359.1-2007, and ANSI A10.32-2012 regulations.
HitchClip™ is compatible with the following applications:
HitchClip™
Part #: 10560, 10561, 10562,10563, 10564, 10566, 10567, 10568
Personal Fall Arrest: HitchClips™ may be used to support a MAXIMUM 1 Personal Fall Arrest System (PFAS) for use in Fall Arrest applications.
Structure must withstand loads applied in the directions permitted by the system of at least 5,000 lbs. Maximum free fall is 6‘, or up to 12’ if
used in combination with equipment explicitly certified for such use. Applicable D-ring: Dorsal.
Restraint: HitchClips™ may be used in Restraint applications. Restraint systems prevent workers from reaching the leading edge of a fall
hazard. Always account for fully deployed length of lanyard/SRL. Structure must withstand loads applied in the directions permitted by the
system of at least 1,000 lbs. No free fall is permitted. Restraint systems may only be used on surfaces with slopes up to 4/12
(vertical/horizontal). Applicable D-rings: Dorsal, Chest, Side, Shoulder.
Capacity range (including all equipment): 130 - 310 lbs., or up to 420 lbs.
if used in combination with equipment explicity certified for such use.
Rescue/Confined Space: HitchClips™ may be used in Rescue/Confined Space applications. Rescue systems function to safely recover a worker
from a confined location or after exposed to a fall. There are various configurations of Rescue systems depending on the type of rescue.
Structure must withstand loads applied in the directions permitted by the system of at least 3,000 lbs. No free fall is permitted. Applicable
D-rings: Dorsal, Chest, Shoulder.
Work Positioning: HitchClips™ may be used in Work Positioning applications. Work Positioning systems allow a worker to be supported while
in suspension and work freely with both hands. Structure must withstand loads applied in the directions permitted by the system of at least
3,000 lbs. Maximum allowable free fall is 2’. Applicable D-rings: Side, Shoulder.
Maintenance, Cleaning, and Storage
Repairs to HitchClips™ can only be made by a Guardian Fall Protection representative or an entity authorized by Guardian. Contact Guardian for all
maintenance and repair needs at: 1-800-466-6385. If a HitchClip™ fails inspection in any way, immediately remove it from service, and contact Guardian to
inquire about its return or repair.
Proper care is important for maintaining the safety and longevity of HitchClips™. Remove all dirt, corrosives, and contaminants from HitchClip™ before and
after each use. If HitchClip™ cannot be cleaned with plain water, use mild soap and water, then rinse and wipe dry. NEVER clean HitchClip™ with corrosive
substances. When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals, or other degrading elements.
Inspection
User must inspect prior to EACH use. Competent Person other than user must complete
formal inspection at least every 6 months. Competent Person to inspect and initial.
Date of First Use: __________________. Product lifetime is indefinite as long as it
passes pre-use and Competent Person inspections.
This inspection log must be specific to one HitchClip™. Separate inspection logs must be
used for each HitchClip™. All inspection records must be made visible and available to all
users at all times.
If equipment fails inspection IMMEDIATELY REMOVE FROM SERVICE.
DO NOT THROW AWAY THESE INSTRUCTIONS!
!
WARNING
Use of equipment in unintended applications may result in serious
injury or death. Maximum 1 attachment per connection point.
!
WARNING
IMMEDIATELY remove from service if exposed to forces of fall arrest.
For use by trained personnel only.
Qualcraft Industries 60 Maple St., P.O. Box 36, Mansfield, MA 02048 phone: [phone] www.qualcraft.com