Product Manual

Assemble Sawhorse as indicated by diagram shown below: 1) Ensure Sawhorse Legs and

Locking Strap components lap right over left when in an upright position; 2) Insert bolt through

top of Sawhorse Legs and tighten with

10mm wrench until snug; 3) Insert bolt through center

of both Locking Straps, secure with nut, and tighten with

10mm wrench until snug; 4) In order,

insert bolt through Sawhorse Leg, washer, Locking Strap, and Pinch Guard, secure with nut, and

tighten with

10mm wrench until snug. DO NOT over-torque nuts.

WARNING

NEVER use Sawhorse as a scaffold or for purposes of fall protection. NEVER make any connections to

Sawhorse. Sawhorse must be stable during use. NEVER climb or lean on Sawhorse. Use away from

hazards including, but not limited to, extreme temperature, corrosive substances, and electrical shock.

With extended use, Sawhorse Leg Brackets may loosen from the 2”x4” cross-member. Prior to

EACH use, check gripping teeth for maximum contact with wood to ensure stability of Sawhorse

system. Always use your foot to clamp and unclasp Sawhorse Legs from 2“x4” board. Locking

Straps may injure hand or fingers if used to open and close Sawhorse Leg Brackets.

www.qualcraft.com1-800-231-5647 60 Maple St., P.O. Box 36

Mansfield, MA 02048

Trojan Sawhorse Part #: TS27; TS35

Nut

Pinch

Guard

Locking

Strap

Washer

Sawhorse

Leg

Bolt

All Leg and Locking Strap

components lapped

right over left.

Nut

Bolt

Nut

85008 (Rev. D)

QUALITY TOOLS