Installation & Assembly

ManualsBrandsQualGear ManualsCeiling Projector Mount Projector MountsUniversal Ceiling Mount

M-M

CAUTION!

Do not exceed the maximum rated weight

specified. Otherwise, serious injury or

property damage may occur.

Your projector ceiling mount is now installed.

To make adjustments, loosen up the screws slightly

with the alley key (M-M). When you are satisfied

with the adjustments, tighten up the screws again.

20kg

(44lbs)

RATED

PROJECTOR CEILING MOUNT

QG-PM-002-BLK

IMPORTANT:

Use an assistant for this step to hold projector

securely. Do not loosen screws all the way

when making adjustments, this will disconnect

the parts and may cause injury or property

damage.

Summary of content (6 pages)

PAGE 1
QG-PM-002-BLK PROJECTOR CEILING MOUNT Your projector ceiling mount is now installed. To make adjustments, loosen up the screws slightly with the alley key (M-M). When you are satisfied with the adjustments, tighten up the screws again. IMPORTANT: Use an assistant for this step to hold projector securely. Do not loosen screws all the way when making adjustments, this will disconnect the parts and may cause injury or property damage.
PAGE 2
NOTE Please read the entire installation manual before you start installation and assembly. WARNING  Do not begin to install your QualGear product until you have read and understood all the instructions and warnings contained in this installation manual. If you have any questions regarding the instructions, for US customers please contact QualGear customer support via email at support@qualgear.com. For all international customers, please contact your local distributor.
PAGE 3
1 NOTE Cable Management N 5mm Make sure the installation direction of the decorative cover is correct.
PAGE 4
2 Installing the Projector Ceiling Mount Assembly 3a Mounting to a Wooden Ceiling Attach the adjustable extension column to the ceiling plate with four M6 screws (M-B) and four D6 washers (M-L) using a 5mm allen key (M-N) as shown below. M-L For concrete ceiling mounting, follow Step 3b. For mounting to drywall, use toggle anchors (not included). A Ceiling Plate M-B B Adjustable Extension Column 2 1 Using an edge-to-edge stud finder, find the edges of the stud.
PAGE 5
3b Mounting to a Brick or a Concrete Ceiling Do NOT use power drill and do NOT over tighten the lag bolts. W-B W-C W-A W-B 1 W-C Hold the marking template provided against the ceiling where you want to install the projector, mark four holes for drilling. W-A 70mm (2.7") ø 10mm (ø 3/8") 2 Place concrete anchors (W-B) in each hole. Tap each anchor flush with the ceiling surface using a hammer. Mount the ceiling plate and tighten with the lag bolts (W-A) and washers (W-C) using a socket wrench.
PAGE 6
4 Installing Adapter Bracket to the Projector Connecting the Projector Mount Assembly to the Extension Column 5 M-O/ M-P/ M-Q 1 M-H/ M-I/ M-J/ M-L M-C/ M-D/ M-E/ M-F/ M-G M-N To adjust the height of the extension column, loosen the clamp plate screw with the 5mm allen key (M-N), adjust the extension column to a desired position, and then tighten the clamp plate screw as shown on the left.