Installation & Assembly

ManualsBrandsQualGear ManualsCeiling Projector Mount Projector MountsUniversal Projector Ceiling Mount, Short

CAUTION!

Do not exceed the maximum rated weight

specified. Otherwise, serious injury or

property damage may occur.

13.5kg

(29.7lbs)

RATED

13.5kg

(29.7lbs)

RATED

Your projector ceiling mount is now installed.

To make adjustments, loosen up the screws

slightly with the alley key (M-P). When you are

satisfied with the adjustments, tighten up the

screws again.

Summary of content (6 pages)

PAGE 1
Your projector ceiling mount is now installed. To make adjustments, loosen up the screws slightly with the alley key (M-P). When you are satisfied with the adjustments, tighten up the screws again. CAUTION! 13.5kg (29.7lbs) RATED Do not exceed the maximum rated weight specified. Otherwise, serious injury or property damage may occur.
PAGE 2
NOTE Please read the entire installation manual before you start installation and assembly. WARNING  Do not begin to install your QualGear product until you have read and understood all the instructions and warnings contained in this installation manual. If you have any questions regarding the instructions, for US customers please contact QualGear customer support via email at support@qualgear.com. For all international customers, please contact your local distributor.
PAGE 3
1 2a Mounting to a Wooden Ceiling Cable Management NOTE For concrete ceiling mounting, follow Step 2b. A Ceiling Plate with Connector 1 Feed the projector cable(s) through the top of the Ceiling Plate. 2 Using an edge-to-edge stud finder, find the edges of the stud. Using a straight edge, mark the centerline of the stud. 65mm (2.5") OR ø 4.5mm (ø 3/16") 4 Using the marking template provided, mark two holes for drilling on the centerline of the stud.
PAGE 4
NOTE 2b Mounting to a Concrete Ceiling Do NOT use power drill and do NOT over tighten the lag bolts. X Wooden Ceiling W-C W-A 1 Hold the marking template provided against the ceiling where you want to install the projector, mark four holes for drilling. 70mm (2.7") 5 ø 10mm (ø 3/8") Using a socket wrench, mount the ceiling plate and fasten with the provided lag bolts (W-A) and D6 washers (W-C). WARNING  Installers are responsible to provide hardware for other types of mounting situations.
PAGE 5
NOTE Do NOT use power drill and do NOT over tighten the lag bolts. Installing Projector Mounting Bracket to the Projector 3 B Projector Mounting Bracket Concrete Ceiling M-A/ M-B/ M-C/ M-D Projector M-L M-I/ M-J/ M-K Recessed Hole W-B W-B M-E/ M-F/ M-G/ M-H NOTE W-C W-A Choose the appropriate spacer (M-I/ M-J/ M-K) when mounting to recessed holes.
PAGE 6
4 Installing the Projector Celing Mount Assembly This mount allows pitch NOTE and roll adjustments for a HEAVY! Use an assistant for this step. M-O perfect viewing experience. M-N Ceiling M-M A Ceiling Plate with Connector M-P Projector Projector Mounting Assembly Align the Projector Mount Assembly to the Celing Plate with Connector, then using the Alley Key (M-P), attach them together with the provided Screws (M-M), Washers (M-N), and Plastic Washers (M-O).