User Manual Part 4
175
Replacing the main hard drive
www.gateway.com
Replacing the main hard drive
If you would like more hard drive capacity, you can install a second hard drive
or replace your original drive with a higher-capacity drive. To replace the drive,
follow the instructions below.
To replace the main hard drive:
1 Follow the instructions under “Preventing static electricity discharge” on
page 171 for important precautions.
2 Turn off the notebook (do not go to Hibernate mode) and close the cover.
3 Disconnect the power and modem cables.
4 Turn the notebook over, then remove the main battery (and second
battery, if installed). For more information, see “Changing the main
battery” on page 132 and “Installing a second battery” on page 134.
5 Remove the security screw. (Solo 9500 only.)
Warning Disconnect the power supply cord, remove the battery, and
disconnect the modem cable before you remove the hard
drive. Replace the hard drive before you restore power or
reconnect the modem cable.
Solo9550.book Page 175 Tuesday, June 19, 2001 3:18 PM