User's Manual

Chapter 2. Learning the basics



Using VeriFace™

VeriFace is a face recognition software which takes a digital snapshot,

extracts key features of your face, and creates a digital map that becomes

the system’s “password”.

VeriFace needs to be enrolled the face image at your first-use of the

computer by clicking the icon of VeriFace on the desktop to run VeriFace

enrollment wizard.

For more instructions on VeriFace, see the help file on your software.



Using passwords

Using passwords helps prevent your computer from being used by others.

Once you set a password and enable it, a prompt appears on the screen

each time you power on the computer. Enter your password at the prompt.

The computer cannot be used unless you enter the correct password.

For details about how to set the password, see the help to the right of the

screen in BIOS setup utility.

Notes:

• The face registration and verification works best in an environment with steady

and even light.

• If the computer is in the notebook mode, VeriFace rather than VeriTouch will run

when you logon the system.

Note: This password can be from one to eight alphanumeric characters in any

combination.

S10-3t UserGuide V1.0_en.book Page 23 Friday, October 23, 2009 12:57 PM