User's Manual

z Create a dial-up modem connection between your device and a Bluetooth
phone. You can then use the Bluetooth phone as a modem.
4.1.5.1 Bluetooth settings
To access the Bluetooth settings screen, tap WF > Settings > Connections tab
>Bluetooth.
To turn Bluetooth on or off, check/uncheck the Turn on Bluetooth option.
With Bluetooth off, you cannot use Bluetooth to either send or receive information.
You might want to turn the radio off at times in order to conserve battery power, or
in situations where radio use is prohibited, for example on airplanes and in
hospitals.
By default, the Bluetooth radio is turned off. If you turn it on, and then turn off
your device, the Bluetooth radio also turns off. When you turn on your device
again, the Bluetooth radio automatically turns on the radio. If you wish to turn on
the radio, turn off Bluetooth first, and then turn on the radio.
To make your device discoverable, check Make this device discoverable to
other devices option.
If the Bluetooth radio is turned on, then all of the other Bluetooth devices within
range (about 10 meters) can detect your device and attempt to beam information
to it, establish a bond, or use a Bluetooth service. In this mode, other devices can
detect your device whether or not a bond has been created; however, in order to
receive a beam from another device, you must accept it on your device.
Other Bluetooth devices can now detect your device and attempt to beam
information to it, establish a bond, or use a Bluetooth service. Note that, to receive
beamed information, you must accept it on your device by selecting Discoverable;
this also turns on your Bluetooth radio.
If you no longer want your device to be discoverable, uncheck the Turn on
Bluetooth option or uncheck the Make this device discoverable to other
devices option to leave the radio on, but not allow detection by other devices.
4.1.5.2 Bonds
To exchange information in a secure manner, you may use a bond to create a
relationship between your Pocket PC Phone and another Bluetooth device. To
create a bond, you need to enter the same personal identification number (PIN)
on the two devices that you want to bond. You need only create a bond once
between two devices. Once a bond is created, the devices recognize the bond
and are able to exchange information without your needing to enter a PIN again.