User's Manual

To create a Bond
You can create a bond between your device and another device that has
Bluetooth. Once you do this, Bluetooth doesn’t need to be in discoverable mode in
order for you to beam information between the two devices; you only need to have
the Bluetooth radio turned on.
1. Tap WF > Settings > Connections tab.
2. Tap Bluetooth > Devices tab > New Partnership. Your device searches for
other Bluetooth devices and displays them in the list.
3. Tap the name of the other device in the list, and then Next.
4. In PIN, enter a PIN of between 1 and 16 characters and tap Next.
5. Enter the same PIN on the other device.
6. If necessary, in Name, edit the name of the other device.
7. Tap Finish.
Please note:
Make sure that the two devices are within 10 meters of one another and that
Bluetooth is in discoverable mode on both devices.
To accept a Bond:
1. Make sure that Bluetooth is turned on and in discoverable mode.
2. When prompted to bond with the other device, tap OK.
3. In PIN, enter a PIN of between 1 and 16 characters, and tap Next. You must
enter the same PIN that was entered on the device requesting the bond.
4. If you want, in Name, edit the name of the device requesting the bond.
5. Tap Finish.
The bond is created. You can now exchange information with the other device.
To rename a Bond
1. Tap WF > Settings > Connections tab.
2. Tap Bluetooth > Devices tab.
3. Tap the bond to rename.
4. In Name, enter a new name for the bond.
5. Tap Finish.
格式化: 縮排: 左: -0.33 字元,
編號 + 階層: 1 + 編號樣式: 1,
2, 3, … + 起始號碼: 1 + 對
齊方式: 左 + 對齊: 0.85 cm +
定位點之後: 1.48 cm + 縮排:
1.48 cm, 定位點: 0.5 cm, 清
單標籤 + 不在 0.63 cm + 1.48
cm