Manualshelf

User's Manual

ManualsBrandsQuanta Computer ManualsElectronicsWearable ECG Monitoring Device
21222324252627282930
QUANTA COMPUTER INC. Wireless Home Health Management System
____________________________________________________________________________
___________________________________________________________________________
User Manual V1.0 Page: 22
Bluetooth matching (These settings will be set by the service representative)
(1) When the “Smart Phone” or “NYA Monitor” is used for the first time or
updated they must be paired.
(2) Open the smart phone and make sure that it has Bluetooth enabled (See E.
Smart Phone Instructions).
(3) Use the pin to press the Bluetooth pairing button on the “NYA Monitor” to
start pairing.
(4) During the pairing process, the LED status light will alternatively blink
green/orange for 1 minute.
(5) Once pairing is successful, the green LED will stay lit for 5 seconds and the
mobile phone will show that it is connected.
(6) If pairing fails, the LED status light on the monitor will alternatively blink
green/orange for 1 minute then stop pairing and searching. All lights will then
go out.
Instructions for the Body Monitor
(1) Clip the ECG electrode's male connector to the female connector on the
accessory as shown below:
(2) Remove the paper strip from the ECG electrode. For step 1, attach the
device-side to the lower edge of the left chest. For step 2, attach the wire-side
to the lower edge of the right collarbone as shown below:
Device-side
Wire-side