User's Manual

Pairing
After creating a profile, the Q-COR app will prompt you to pair the sensor to your
smartphone. To pair the sensor to your smartphone:
1. Use the pin included in the package to push the Bluetooth pairing button on the
sensor.
2. The status indicator on the sensor will alternately flash orange and green indicating
that it is in pairing mode.
3. Once the sensor is in pairing mode tap OK on your smartphone.
4. Wait until you get a message on your smartphone indicating that the pairing was
successful.
NOTE: After pushing the Bluetooth pairing button the sensor will stay in pairing mode for 1 minute. If
pairing has not been completed during that time push the pairing button and follow the steps above again.
NOTE: Not all smartphones can pair with the ECG sensor directly through the Q-COR app as Bluetooth
functionality may vary depending on smartphone model. In cases where pairing within the Q-COR app
fails (as shown in the screenshot below), enter the Bluetooth menu in the Android Settings menu
(Settings > Bluetooth > Pairing) and proceed to pair the two devices directly from there.