FEDERAL COMMUNICATIONS COMMISSION NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
1. Getting Started Package Contents Congratulations on your purchase of the high quality KX1 LCD Monitor. Your KX1 Monitor package includes the following: * KX LCD Monitor * VGA cable with 15 pin D-Sub connector * AC adapter (19 VD) + Power cord * Audio cable with 3.3 mm ear phone plug * User's Guide * Software diskette of Display Quality Check utility Note: Save the original box and all packing material for future shipping needs. Connecting the KX1 LCD Monitor The rare panel of KX1 is shown 2s the figure.
2. Operation Note: For best performance set your computer to 1024 x 768 resolution with 16 bits or 24 bit colors. See the user guide that came with your computer for instruction. Lower resolutions degrade display quality. Front Panel Jl [— < loveless— 5! All operation controls and volume adjustment are located at the front panel. The figure shows the function of them. * VO: The power switch. To turn on the KX1, press the power switch and the power LED will light.
Power Management System This KX1 meets VASE DIMS (Display Power Management Signaling) standards, For the power saving feature to work, the video board or computer must also meet VASE DIMS standards. State LED | Power | Recovery Time On Green | 30W | N/A Standby Orange sec Off None sec The KX1 goes into the power saving stages with the following video synchronization signals: State | H-Sync | V-Sync Off Standby Of To conserve energy. we recommend tuning off the K> for long period of time.
Factory Preset Timings V-Syn¢ H-sync TERR aR IE 877 640 xl 48067 TT 35 CU 840 WAS TTT ars TC B40 x BO, 75 ITE 127 720% 350780 1477800 Tk B00 5B (1577800 TX B00 EC TEE [x B02 17800 x B00 TTS ig : 7207 T024xG BIRETTAS ETT [190d x TeE (024 565 22 T0247 x, 7887 72 581 3.
4. Trouble Shooting If your KX1 LCD Monitor Is not operating properly, use this trouble-shooting chart for quick solutions to common problems. If the problem still exists, call your monitor dealer. Problem... Possible Cause... What to do... No picture, LED off Power cord disconnected Connect the power cord. Power switch off Turn on the power switch. Faulty AC outlet Try another AC outlet. No picture, LED on Video cable connection Connect VGA cable properly.
3. Technical Data Specifications LCD Type 14.5 inch TFT color LCD module, 18-bit color, 0.288 mm pixel pitch Display Area 294.9 x221.2 mm (15.4 inch) Surface Anti-glare, hard coat Input Signal Video RGB analog VP-p, 75 ohms) Synge H/V separate (TTL) Compatibility PC IBM® XT, AT, 386, 486, Pentium® or PS/2 and compatible (from VGA unto 1024 x 768 non interlaced) Connectors Front Headphone-Out 3.5 mm stereo phone jack Rear Video-In Mini D-Sub 15 pin female Line-In 3.
* H Position: adjust the horizontal position of display. * V Position: adjust the vertical position of display. * Phase: adjust the phase position of data sampling. See details in next section. + Clock: adjust the number of clocks for each horizontal line. * Video Utility: enter a sub-menu for video adjustment. They are: * R,G,B: separated control of each Red, Green, and Blue colors, Usually set to same value for all three colors. * Input Level: select between 0.
+ Large screen area compatible with conventional 17” CRT monitors. * Supports 16 million color in VGA, SAGA, and VGA resolution. + Multi-scan ability to accept horizontal frequencies from 25 to 60 KHz and vertical frequencies from Ergonomic Design * Anti-glare coating reduces eyestrain. + Tilt base allows 30 Imitation vertically for user comfortable. ¢ Low magnetic field or electrostatic charges for increased user safety.
