User's Manual

ThisdeviceisintendedonlyforOEMintegratorsunderthefollowingconditions:
(1)Theantennamustbeinstalledsuchthat20cmismaintainedbetweentheantennaandusers, 
(2)Thetransmittermodulemaynotbeco‐locatedwithanyothertransmitterorantennaexceptas
describedbelow.
(3)TocomplywithFCCregulationslimitingbothmaximumRFoutputpowerandhumanexposureto
RFradiation,themaximumantennagainincludingcablelossinamobileexposureconditionmust
notexceed:
StandaloneCondition:
。 5.0dBiin1700MHzBand
。 9.0dBiin700MHzBand

AssumingcollocatedwithaWLANtransmitterwithmaximum34dBmaverageEIRPpower
。
 5.0dBiin1700MHzBand
。
 6.0dBiin700MHzBand
Remark:ThisassumptionisnotvalidiftheoutputpowerofthecollocatedWLANtransmitteris
higherthan34dBm.

Intheeventthattheseconditionscannotbemet(forexamplecertainlaptopconfigurationsor
co‐locationwithanothertransmitter),thentheFCCauthorizationisnolongerconsideredvalidand
theFCCIDcannotbeusedonthefinalproduct.Inthesecircumstances,theOEMintegratorwillbe
responsibleforre‐evaluatingtheendproduct(includingthetransmitter)andobtainingaseparate
FCCauthorization.Aseparateapprovalisrequiredforallotheroperatingconfigurations,including
portableconfigurationswithrespectto2.1093anddifferentantennaconfigurations.

Toensurecompliancewithallnon‐transmitterfunctions,thehostmanufacturerisresponsiblefor
evaluatinghostsystemforPart15subpartBrequirement.



