User Manual
Table Of Contents
- “Trilogy 3” MPCI
- Introduction
- Trilogy 3 Product Overview
- Document Purpose
- Key Features
- What’s Not Supported
- References
- WLAN System Architecture
- WLAN Block Diagram
- WLAN Component Descriptions
- WLAN Transmitter Path
- WLAN Receive Path
- WLAN Microprocessor Control
- WLAN Frequency Generation
- WLAN Hardware Environment
- WLAN Power Requirements
- Modem System Architecture
- Modem Block Diagram
- Modem Hardware Environment
- Modem Power Requirements
- Environmental Performance
- Regulatory
- Ethernet Software Driver and Feature Set
- Modem Software Driver and Feature Set
- Operating System Software Support
- AC’97 Modem Driver Package File Description
- SETUP Usage
- SETUP Customization
- Multilanguage Support
- LTHOMOL.exe (Homologation support utility)
- LTSMMSG.exe (User messaging & system audio support utility)
- Selection of Un-homologated Country Messaging
- Over Current Protection (OCP) Messaging
- System Audio Support
- Quality
Trilogy 3 MPCI
M3AWEB/56GA
Product Specification
LTSMMSG.exe (User messaging & system audio support utility)
LTSMMSG.exe is a stand-alone program that offers you to show pop-up
windows to indicate users for certain critical events occurred, while users are
using the modem function. This program supports all Windows operating
systems.
Selection of Un-homologated Country Messaging
If the user selects some country which the modem is not homologated, either
from Regional Settings and/or Modem, Dialing Properties, My Location in Control
Panel, this warning message will show up.
Modem is not approved in the selected country.
Selecting a country other than the one in which you are currently
located may cause your modem to be configured in a way that
violates the telecommunication regulations/laws of that country.
In addition, your modem may not function properly if the correct
country selection is not made. Only select the country in which you
are located.
Country/region setting of the modem will remain the same as it was before if an
un-homologated country/region is selected. In addition the modem function itself
will not be blocked by this program.
To enable this feature the following line is needed in the INF file(s) for each
operating system.
[PortMod.AddReg]
HKLM,SOFTWARE\Microsoft\Windows\CurrentVersion\Run,LTSMMSG,,LTS
MMSG.exe
(Launch LTSMMSG.exe upon Windows boot-up.)
Intel Confidential – Controlled Access
Page 26 of 29