User Manual
Table Of Contents
- “Trilogy 3” MPCI
- Introduction
- Trilogy 3 Product Overview
- Document Purpose
- Key Features
- What’s Not Supported
- References
- WLAN System Architecture
- WLAN Block Diagram
- WLAN Component Descriptions
- WLAN Transmitter Path
- WLAN Receive Path
- WLAN Microprocessor Control
- WLAN Frequency Generation
- WLAN Hardware Environment
- WLAN Power Requirements
- Modem System Architecture
- Modem Block Diagram
- Modem Hardware Environment
- Modem Power Requirements
- Environmental Performance
- Regulatory
- Ethernet Software Driver and Feature Set
- Modem Software Driver and Feature Set
- Operating System Software Support
- AC’97 Modem Driver Package File Description
- SETUP Usage
- SETUP Customization
- Multilanguage Support
- LTHOMOL.exe (Homologation support utility)
- LTSMMSG.exe (User messaging & system audio support utility)
- Selection of Un-homologated Country Messaging
- Over Current Protection (OCP) Messaging
- System Audio Support
- Quality
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as the 2 conditions above are met, further transmitter testing will not be required. However,
the OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final product. In these circumstances, the
OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and
Obtaining a separate FCC authorization.
End Product Labelling
This transmitter module is authorized only for use in devices where the antenna may be installed such
that 20 cm may be maintained between the antenna and users (for example access points, routers,
wireless ASDL modems, and similar equipment). The final end product must be labeled in a visible
area with the following: “ Contains TX FCC ID: HFSM3AWEB ”.
Manual Information That Must be Included
The users manual for end users must include the following information in a prominent location “
IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and
must not be co-located or operating in conjunction with any other antenna or transmitter.”