User's Manual

error
Check date and
time settings
The BIOS found the system time out of range and reset the Real Time Clock. Run
Setup and reconfigure the date and time.
Previous boot
incomplete -
Default
configuration used
POST loads default values and offers to run Setup. If the failure was caused by
incorrect values and they are not corrected, the next boot will likely fail.
On systems with wait states, improper Setup settings can also terminate POST and
cause this error on the next boot. If applicable,
run Setup and verify that the wait-state
configuration is correct. This error is cleared the next time the system is booted
Diskette drive A
error.
Drive A: is present but fails the BIOS POST diskette tests. Check to see that the drive
is defined with the proper diskette type in
Setup.
Incorrect Drive A
type - run Setup
Type of floppy drive A: not correctly identified in Setup.
System cache
error - cache
disabled
The RAM cache failed, and the BIOS disabled the cache. Contact your authorised
service representative.
Failing Bits: nnnn The hex number nnnn is a map of the bits at the RAM address (in System, Extended,
or Shadow memory) which failed the memory test. Each 1 (one) in the map indicates a
failed bit.
Operating system
not found
An Operating system cannot be located on either drive A: or drive C:. Enter Setup and
see if fixed disk and drive A: are properly identified.
Parity Check 1
nnnn
A parity error was found in the system bus. The BIOS attempts to locate the address.
If it cannot locate the address, it displays ????.
Parity Check 2
nnnn
A parity error was found in the I/O bus. The BIOS attempts to locate the address. If it
cannot locate the address, it displays ????.
Start-Up Problems