User's Manual

Floppy Disk Drive
LEDs and Controls
The front bezel of the floppy disk drive may feature the following LEDs and controls:
Diskette release button
- press this button to release a diskette from the floppy disk drive.
Floppy disk drive busy lamp
- lights when the diskette drive is reading from or writing to a diskette.
Using Floppy Disks
Follow these steps to insert a 3.5-inch floppy disk in the standard floppy disk drive.
1. Hold the floppy disk at its top edge and insert the diskette label side facing up.
2. Insert the floppy disk all the way into the drive until you hear a click.
Note
: if your floppy disk did not come formatted, you must format it before storing information on it. See your
operating system documentation for information about formatting a diskette.
To remove a diskette from the diskette drive, press the release button on the 3.5-inch diskette drive.
Caution
: do not remove a diskette from the diskette drive when the diskette drive lamp is lit. Doing so can
damage both the data on the diskette and the drive. Do not turn off the system power while the diskette is
being accessed.
Floppy Disk Drive