User's Manual

Serial Devices
To install a serial device such as a printer or an external modem, you need a cable with a female 9-pin
connector.
Note:
in Windows, when you connect a printer or modem, be sure to install the appropriate driver through the
Control Panel.
Connect a serial device to your system as follows.
1. Check that power to both the Versa and the device is off.
2. Align and connect the 9-pin connector with the serial port on the system. Secure the connection with
the screws provided.
3. Align and connect the other end of the cable to the appropriate port on the device. Secure the
connections with the screws provided.
4. Connect the power cable to the device and a properly grounded wall outlet.
5. Follow any specific set-up instructions in the device's user's guide.
6. Turn on power to the system and the device.
Note:
make sure your device is online before trying to use it. Refer to the device's documentation for
instructions.
Serial Port