User's Manual

Sensor v2 User Manual
Instructions:
Chalk Lines:
 Measure half the depth of a spot in from the top of the spot and mark. Do the same on the other
end of the line
 Chalk a line between the two ends
 Go through each spot and mark the midpoint on the chalk line to find the center of the spot
where the sensor will go
Surface Lot (Recessed Installation):
 Use a 4.25" core drill bit and drill 1.25" deep into the center of the spot
 Use a chipping gun to chip out the inside of the core drilled hole
 Use a vacuum or gloves to clear out dust/debris from the hole
 Put in self leveling (SL) adhesive around the edge of the hole and on the bottom of the sensor

 Put the sensor in the hole so the top is level with the ground
 Default orientation is with the Parkifi 'P' facing up in the spot at 12 o'clock
 If the antenna is in the direction of the top or bottom of the 'P', rotate the sensor 90 degrees so
that the top of the 'P' is now at 3 o'clock
 Put adhesive around the outside of the hole to fill in the gaps around the sensor. Put adhesive
around the top of the sensor to cover the four screws
 Go to Installifi > Zones > View Spots and run base_recalibration on the spot. Wait 3 minutes
then check to see that the Sensor Calibrated At time is populated
 Go to Installifi > Zones > View Spots and run cloud_recalibration on the spot. Verify that the
Cloud Calibration Start Time is populated and wait 7 minutes. After those 7 minutes are up the
spot is complete