User's Manual

Garage (Surface Mounted Installation):
 Lay all sensors into the center of the spots as determined by your chalk lines
 Go to Installifi > Zones > View Spots and run base_recalibration on all sensors in the zone.
Running a base_recal allows the sensors to start reporting magnetometer data
 Go to each sensor page and check the Sensor History Series Data. Hover over the furthest-right
point to see the X, Y and Z magnetometer values
 Check that all values are less than the absolute value of 1200 (less than 1200 or greater
than -1200)
 If any values are outside of that threshold, move the sensor a couple inches to the left or
right in the spot, wait a couple minutes and check values again. Repeat until you find a
point near the center of the space that has good magnetometer readings (less than
absolute value 1200)
 We prefer to move sensors left and right in the spot to keep the aeshetic so that if
someone looked down the line of sensors they'd all be in line
 Put high viscosity (HV) adhesive on the bottom of the sensor and stick it in the spot
 Default orientation is with the Parkifi 'P' facing up in the spot at 12 o'clock
 If the antenna is in the direction of the top or bottom of the 'P', rotate the sensor 90
degrees so that the top of the 'P' is now at 3 o'clock

 Put high viscosity (HV) adhesive around the outside of the ring. Put the ring down around the
sensor and stand on it