User's Manual

WF-100 CompactFlash Wireless LAN Card User Manual
                                                                                                                                        
                               
________________________________________________________________________
Page: 49
l Not Associated
– the station cannot detect any available station with the specified
SSID in the
Peer-to-Peer Mode
.
Current Tx Rate
Display the transmission rate of the current communication.
Current Channel
Display the channel of the current wireless connection. The communication channel ranges
from
1 to 11(US/FCC, Canada/RSS)
,
1 to 13(Europe/ETSI) or 1 to 14(Japan/TELEC)
Power Save
Indicate the power saving mode is being enable d or disable d. Power saving mode can reduce
the power usage by temporarily disconnecting wireless connections when the connection is
idle.
Throughput
Contain two fields displaying the instantaneous wireless receiving (Rx) and transmitting (Tx)
throughput values in bytes per second. These numbers are updated every second.
Signal Level
A series of figures indicate the current signal level and WEP state. All figures are described
below.
WEP disable d
The station receives excellent signals.
The WEP is disabled.
The station receives good signals.
The WEP is disabled.
The station receives fair signals.
The WEP is disabled.
The station receives a little bit weak signals.
The WEP is disabled.
The station only receives a little feeble signal.
The WEP is disabled.
The station cannot receive any signal.
The WEP is disabled.
WEP enabled / WEP matched
The station receives excellent signals.
The WEP is enabled and the decryption key
matches
the key of the sender.
The station receives good signals.
The WEP is enabled and the decryption key
matches
the key of the sender.