User`s manual

Pressing the RUN/STOP key will now generate a continuous stream of pulses.
To Use Channel Single Shot Function
The Single Shot mode generates a single pulse every time the RUN/STOP key
is pressed. To use the Single Shot mode:
- within the Channel menus
Enable Select Enable to enable channel output.
Delay Set the desired delay.
Width Set the desired pulsewidth.
Mode Select the Single shot mode.
To Use Channel Burst Mode Function
The Burst mode generates a burst of pulses every time the RUN/STOP key is
pressed. To use the Burst mode:
-within the Channel menus
Enable Select Enable to enable channel output.
Delay Set the desired delay.
Width Set the desired pulsewidth.
Mode Select the Burst mode.
#/Burst Set the number of pulses to produce in the burst.
To Use the Channel Duty Cycle Function
To generate a stream of pulses which oscillates on for n pulses and off for m
pulses:
- within the Channel menus
Enable Select Enable to enable channel output.
Delay Set the desired delay.
Width Set the desired pulsewidth.
Mode Select the Duty Cycle mode.
On Cycle Set the number of pulses to produce during the on
cycle.
Off Cycle Set the number of pulses to skip during the off cycle.
Note: Older Quantum Composers pulse generators had a divide-by-n func-
tion. The duty cycle mode is a more general case. To reproduce the divide-
by-n function, set the on cycle to 1 and set the off cycle to (n-1), where n is
the divide-by-n factor.