Generator Quick Start Guide

• 8 • Model 802 Series Quick Start Guide
802
Clone (Must be exact same model and firmware)
Cloning allows you to program a generator at your desk using
Quantum Data's VGM software and then easily and quickly
transferring the information to other generators of the same
model. You transfer (clone) the entire block of battery backed
user memory (including video formats, custom test images and test sequences)
from one generator to another using a suitable PC memory card. A Type 1,
Battery Backed RAM PC card with at least 2 MB of storage is required. Flash
or compact type memory cards will not work for cloning.
You can use the Archiver function in our VGM software application to transfer
entire blocks of user data from a generator to disk files and then upload the
blocks of data to other models having similar firmware versions. The Archiver
function also supports converting data blocks created with older firmware to be
compatible to be uploaded to models with newer firmware. The VGM software
also supports saving individual video formats, custom test images and test
sequences to disk and then individually uploading them to other models with
most other firmware versions.
PC Card Slot Location
1. Insert a suitable PC memory card
and power up the generator while
holding down the indicated buttons.
Image Video Gate Outputs
STEP R G B ACS DCS DSS ON
Sync Gate
2. Release the buttons and then
select an operation from the following
choices:
A. Write to the Card
Press the Outputs ON button to write
the generator's contents to the card
and resume normal operation.
B. Read from the Card
Press the Image STEP button to
replace all previously saved user data
stored in the generator's nonvolatile
memory with all the data read in from
the card.
B. Cancel Cloning
Press the ACS button to cancel
cloning without making any changes
and resume normal operation.
Power-up Modes
NOTES:
The PC-Memory card can be safely
inserted or ejected while the genera-
tor is powered up but not actively
reading or writing data.
The LCD will display text error mes-
sages for the following conditions:
1) A memory card is not plugged in
when attempting to read or write.
2) Attempting to write to a write
protected memory card.
3) Attempting to read data that was
created with an incompatible firmware
version or corrupted data.
You can either correct the condition
and use the appropriate Outputs or
Image button selection to continue or
the ACS button to cancel and resume
normal operation with no changes.