Owner's manual

881/882 Video Test Generator User Guide (Rev A.22) AOU
2041 Can not repeat field if progressive
Repeat field operation is only supported in interlaced video formats.
2050 Horizontal total too small
The video format’s total (active + blanked) number of pixel clock cycles per horizontal scan
line is below the minimum number supported by the generator hardware configuration.
2059 Invalid Mode
The video format setting is incompatible with the interface selected.
2060 Horizontal total too large
The video format’s total (active + blanked) number of pixel clock cycles per horizontal scan
line is greater than the maximum number supported by the generator hardware
configuration.
2061 Invalid pixel repetition value
The value specified by the NPPP (number of pixels per pixel) to set the repetition factor for
active lines is invalid.
2062 Invalid pixel and clock values
The value specified by the NCPP (number of clocks per pixel) to set the number of clocks
per pixel is invalid.
2063 Invalid embedded aspect ratio
The value specified by the EXAR (extended aspect ratio) parameter is invalid.
2064 HDMI 5V pin is bad
The 5V pin of the HDMI connectors (Pin 18) is monitored by the generator. If the generator
does not detect the 5V on this pin it will issue this error.
2065 Invalid specified border
The value specified for XLBW (left border width), XRBW (right border width), XTBH (top
border height), or XBBH (bottom border height) is invalid.
2066 Invalid XAFD value
The value specified for the active format descriptor (XAFD) parameter was out of range.
2067 Invalid SXEX value
The value specified by the signal from extended aperture map is invalid.