Owner's manual

APF Appendix C Error Messages
2550 Not enough video memory
The generator hardware configuration does not have enough video memory to support the
video format’s combination of active pixels per line (HRES setting) and active lines per
frame (VRES setting).
2551 Insufficient memory
Not implemented at the time this document was created.
2553 No PCMCIA card found in drive
When attempting to download a bitmap no PCMCIA card was detected in the generator’s
PCM slot.
2554 PCMCIA card is write-protected
When attempting to download a bitmap to a PCMCIA card, the PCM card was
write-protected.
2555 PCMCIA card is bad
When attempting to download a bitmap to a PCMCIA card, the PCM card was found to be
bad.
2704 Invalid horizontal physical size
The video format’s horizontal physical size value can not be negative.
2705 Invalid physical size units
The current firmware does not support the type number used for the video format’s units of
measure for physical size (USIZ setting).
2706 Invalid vertical physical size
The video format’s vertical physical size value can not be negative.
2714 Pedestal swing out of range
The video format’s blanking pedestal level (AVPS setting) can not be less that 0.0% of the
peak video level or more than 100.0% of the peak video level.
2715 Gamma correction out of range
The current firmware does not support a video format’s gamma correction factor (GAMA
setting) of less than 0.1 or greater than 10.
2716 Analog video swing out of range
The generator hardware configuration does not support the video format’s analog video
swing value (AVSS setting) for the given analog video type selection.