Owner's manual

881/882 Video Test Generator User Guide (Rev A.22) 121
8. Select BootNow by pressing the adjacent item selection key.
9. The following display appears:
10. Press the + key to boot the generator.
The following display appears and the generator boots up.
11. Press the Tools key. The Tools menu appears on the generator’s display as shown
below.
12. Choose the System item by pressing the adjacent soft key. The System menu appears
on the generator’s display as shown below.
ite
13. Choose the Clone item by pressing the adjacent soft key. The Clone menu appears on
the generator’s display as shown below.
14. Choose the Restore item by pressing the adjacent soft key.
A progress indicator appears. This will take some time.
15. Reconfigure the generator to boot from the Flashmem using the procedures described
in “To boot a generator that is in a stalled state:” on page 119.
16. Restart the generator.
17. If the problem persists you may have to unseat the video board from the main board:
http://www.quantumdata.com/support/videos/video.asp
Press UP arrow
to Boot Now
Quantum Data
Windriver
vxWorks System Boot
Press any key for setup
System
Sequence
Probe
AFC
Analyzer
Reports
ImgShift
CEC
Clock Clone*
CalFactor Server
Network About
Serial GPib
Capture Restore