Owner's manual

238 Chapter 9 Analyzing Digital Sources and Cables
HDMI 1.3
This subsection describes the generator’s video interfaces for the connecting source
devices to the 882EA analyzer. The HDMI video interfaces are shown below.
HDMI interface
The HDMI connector is located on the front of the generator and is labeled “HDMI.” It
emulates an HDMI-compliant video display. The HDMI connector pinouts are shown in the
following table.
HDMI Type A Connector Pinouts
Interface Description
1 HDMI OUT 1 connector outputs full single link HDMI 1.3 deep color video, as well
as DVI and modern HDMI-compatible digital video signals.
2 HDMI OUT 2 connector outputs full single link HDMI 1.3 deep color video, as well
as DVI and modern HDMI-compatible digital video signals.
3 HDMI IN 1 connector for input of full single link HDMI 1.3 deep color video, as well
as DVI and modern HDMI-compatible digital video signals.
4 HDMI IN 2 connector for input of full single link HDMI 1.3 deep color video, as well
as DVI and modern HDMI-compatible digital video signals.
6 SPDIF-IN connector injects audio into the HDMI Tx stream from an external source.
7 SPDIF-OUT connector extracts audio from an incoming source.
Pin Signal Pin Signal Pin Signal
1 TMDS Data 2+ 7 TMDS Data0+ 13 CEC
2 TMDS Data2 Shield 8 TMDS Data0 Shield 14 Reserved (N.C.)
3 TMDS Data2- 9 TMDS Data0- 15 SCL
4 TMDS Data1+ 10 TMDS Clock+ 16 SDA
5 TMDS Data1 Shield 11 TMDS Clock Shield 17 DDC/SEC Ground
6 TMDS Data1- 12 TMDS Clock- 18 +5 V Power
19 Hot Plug Detect
SPECIAL
SPDIF OUT SPDIF IN
INPUT 90-264 YAC
SERIAL DEBUG ETHERNET
GPIB
OUT 2
IN 2
OUT 1
IN 1
1
2
3
4 5 6 7