Owner's manual

252 Chapter 9 Analyzing Digital Sources and Cables
To change a setting value:
a. Position the blinking cursor on the value you want to change. To do this, press the
soft key adjacent to the arrow by the setting value to move the cursor left or right
until it appears on the digit you want to change.
b. Adjust the value of the setting up or down by pressing the + or - keys.
11. To save the changes, press the Enter (Options) key. The following choices appear on
the generator’s display:
To save the changes, choose the Yes item by pressing the adjacent soft key.
To exit without saving the changes, choose the No item.
To return to the parameters screen without saving the changes, choose the Back item.
12. To start the analysis, press the soft key adjacent to Start. The results of the analysis
appear on the generator’s display. Press the soft key next to the arrow to see all of the
results. Refer to the table below for an explanation of the results.
Analysis
Duration
1
Sequences
→
Apply Settings?
Back
Yes No