Owner's manual

380 Chapter 11 CEC Interactive Troubleshooting Environment (ITE)
To test bus arbitration conflicts through the CEC Controller:
1. Access the CEC Controller using the procedures in “To run the CEC Controller:” on
page 370.
2. Select the arbitration test you wish to run.
The table below describes the fields of the Test Arbitration portion of the CEC
Controller dialog box. VERIFY
Refer to the screen shot below which shows enabling the Seize address bus arbitration
test:
L
Setting Function
Seize start bit Holds the start bit on the next incoming session
Seize address bit sets all initiator address bits to 0 on the next
incoming message
Seize data bits sets an incoming data low bit a next incoming
message