Owner's manual

496 Chapter 15 Auxiliary Channel Analyzer
2. In the ACA, from the File menu, select Connect to Analyzer. The Connect to
Analyzer dialog box appears.
3. In the Connect To box, enter the IP address of the generator you want to connect to,
and then click Connect.
4. From DDC menu, point to Port, and the select the port you want to monitor.
5. On the toolbar, click the HDCP button to enable it. Make sure all other buttons are
disabled.
6. From the File pull down menu specify New Trace.
7. Click the Capture activation button.
8. Initiate the actions necessary to cause HDCP transactions to occur. This might be
selecting the HDCPprod image on the generator if the 882 is emulating a source for
testing an HDMI sink.
The ACA begins the trace and displays the results in the main window, as shown below.
T