Owner's manual

881/882 Video Test Generator User Guide (Rev A.22) 505
To set up the generator for DisplayPort:
1. Connect the generator to the DisplayPort device as follows:
a. Sink Testing - The illustration below depicts the setup for monitoring the link layer
transactions during testing of a DisplayPort sink:
b. Source Testing - The illustration below depicts the setup for monitoring the link layer
transactions during testing of a DisplayPort sink:
2. Activate the DisplayPort interface by pressing the Interface key and choosing the
DisplayPort interface as shown below.
Alternatively, to activate the interface through the command line interface, enter the
following commands:
XVSI 10 // Activates the DisplayPort interface
DispPort*