Owner's manual

881/882 Video Test Generator User Guide (Rev A.22) 509
3. Connect an DisplayPort-to-DisplayPort cable between the DisplayPort connector on
the sink device under test and the DisplayPort connector on the 882E labeled To Sink.
The following diagram depicts the test setup for passively monitoring a DisplayPort
source and sink:
4. Run the ACA to view the aux channel transactions. Refer to the procedure “To monitor
the HDCP transactions on the DDC (I2C) bus (channel):” on page 495.
The ACA begins monitoring the transactions and displaying the results in the main
window, as shown below:
T