Quick Start Guide

10 882E Quick Start Guide - HDCP Compliance Testing with Encryption Status Tester (EST) - P/N 68-00210 Rev. B
10. Select Source device by pressing the adjacent soft key to specify that the device under
test is a source.
Alternatively, you can specify the device under test as a source using the following
commands:
CPTX:DUTT 1 // specifies the device under test as a source.
You can query the current value of the parameter with:
CPTX:DUTT? // returns the device under test type.
11. (Optional) Specify the remaining parameters in the EditPCP menu using the table
above.
Alternatively, you can specify the parameters through the command line as follows:
CPTX:SKSV 10 // specifies maximum number of downstream devices
listed in the KSV list of the device under test.
Valid values are 1-127.
CPTX:SRAC 5 // specifies number of times a source DUT attempts
authentication before transitioning into the
authenticated state. Valid values, 1 or greater.
CPTX:SOOR 1 // Indicates whether DUT (source) outputs contents
to repeater with no downstream devices.
1 = yes; 0 = no.
CPTX:SDCZ 0 // indicates whether the 882 should use a downstream
device count of 0 or the device count as specified
by the SKSV command (Source Max KSV).
Note 1: This parameter is only used for the
1B-01 test and this test should be run for both
settings: 0 or 1 (use setting of SKSV).
Note 2: The 882E starting in release 2.17.x will
run these two iterations of the test automatically
in batch mode.
12. Press the Options key to save the capabilities definition.
The generator LCD will display the message “Saved”.
13. Press the Tools key get back to the Reports menu.
The generator LCD will display the reports menu as shown below.
Repeater Max KSV Specifies the maximum number of KSVs the repeater
can read. The valid values are 2 through 127.
Repeater Out OnlyRep Indicates whether the DUT outputs content to the down-
stream repeater that has no downstream device con-
nected. The values are + for yes and - for no.
Parameter Explanation
EDID Packets
Misc HDCP