Quick Start Guide

11 882E Quick Start Guide - HDCP Compliance Testing with Encryption Status Tester (EST) - P/N 68-00210 Rev. B
14. Select HDCP to access the HDCP compliance test menu.
The following is displayed on the generator’s LCD.
15. Select !CompRpt to initiate the HDCP compliance test.
The message “HDCP Compliance Test” is shown and then all the tests are shown in
sequence.
Refer to “To view the HDCP compliance report:” on page 42 for procedures on how to
view the generated report.
Alternatively, you can run the tests using the following command:
CPTX:CPTR 46 // specifies that all applicable tests will be run.
CPTX:CPTU // Initiates the execution of the test
16. Monitor the LCD for a set of prompts during the 1A-01, 1A-09, and 1B-01 tests. When
prompted with the screen shown below, examine the video on the display under test
and press the appropriate button adjacent to the indication (Yes! or No!) to continue.
Note: The prompt asks you if the video appearing on the connected display looks
good. “Looks good” means that there is a picture and an absence of excessive snow.
17. (Optional) To run a specific test with the generator as sink (1A tests), you can use the
command line as shown below:
CPTX:CPTR 1 // Selects specific test (e.g. 1A_01) see table below
CPTX:CPTU // Initiates the execution of the test.
You can query the complete list of tests to choose from:
CPTX:GCTN? // Queries the list of tests supported
You can query the currently selected test to run with:
CPTX:CPTR? // Queries the selected test to run (see table)
18. (Optional) To run a specific test with the generator as repeater (1B tests), you can use
the command line as shown below:
CPTX:CPTR 10 // Selects specific test (e.g. 1B_01) see table below
CPTX:CPTU // Initiates the execution of the test.
You can query the complete list of tests to choose from:
!CompRpt EditPCP
Does the video look
good?
!Yes No!