Quick Start Guide

16 882E Quick Start Guide - HDCP Compliance Testing with Encryption Status Tester (EST) - P/N 68-00210 Rev. B

The following table describes the test parameters and their settings (gray = N/A).

7. Select Sink device by pressing the adjacent soft key to specify that the device under

test is a sink.

The following is displayed on the generator’s LCD.

Alternatively, you can specify the device under test as a sink using the following

commands:

Parameter Explanation

DUT type The type of device under test. This can be one of Sink,

Source, Repeater, Repeater3AB, or Repeater3C. For

this test, select Sink.

Source Max KSV Specifies the maximum number of KSVs the source can

read. The valid values are 1 through 127.

Source Authentication Control Specifies the number of times a source DUT attempts

authentication before transitioning into the authentica-

tion state. The valid values are 1 or greater.

Source Out Only Repeater Indicates whether the DUT outputs contents to a

repeater to which no downstream device is connected.

The values are + for yes and - for no.

Sink 1.1 Features Supported Indicates whether the DUT supports Advanced_Cipher

mode and Enhanced Link Verification. The values are +

for yes and - for no.

Sink 1.1 Audio Supported Indicates whether the DUT supports audio output. The

values are + for yes and - for no.

Repeater 1.1 Features Supported Indicates whether supports Advanced_Cipher mode

and Enhanced Link Verification. The values are + for yes

and - for no.

Repeater Audio Support Indicates whether the DUT supports audio output. The

values are + for yes and - for no.

Repeater HPD Pulse Indicates whether the DUT has the capability to output

HPD pulse by user operation. The values are + for yes

and - for no.

Repeater Max KSV Specifies the maximum number of KSVs the repeater

can read. The valid values are 2 through 127.

Repeater Out OnlyRep Indicates whether the DUT outputs content to the down-

stream repeater that has no downstream device con-

nected. The values are + for yes and - for no.

Sink :DUT Type

+Source_Out_OnlyRep

:Source_Authe_Cnt

:Source_Max_KSV