Quick Start Guide

29 882E Quick Start Guide - HDCP Compliance Testing with Encryption Status Tester (EST) - P/N 68-00210 Rev. B
12. Press the Options key to save the capabilities definition.
The generator LCD will display the message “Saved”.
13. Press the Tools key get back to the Reports menu.
The generator LCD will display the reports menu as shown below.
14. Select HDCP to access the HDCP compliance test menu.
The following is displayed on the generator’s LCD.
15. Select !CompRpt to initiate the HDCP compliance test.
The message “HDCP Compliance Test” is shown and then all the tests are shown in
sequence.
Alternatively, you can run the tests using the following command:
CPTX:CPTR 46 // specifies that all applicable tests will be run.
CPTX:CPTU // Initiates the execution of the test
Refer to “To view the HDCP compliance report:” on page 42 for procedures on how to
view the generated report.
16. Monitor the 882E LCD for a set of prompts during the 3B-01 test.
a. When prompted shown below occurs, power cycle the device under test:
b. Press the button adjacent to the Next! indication after the device under test is back
on to continue.
c. When prompted with the screen shown below, examine the video on the display
under test and press the appropriate button adjacent to the indication (Yes! or No!)
to continue.
EDID Packets
Misc HDCP
!CompRpt EditPCP
Please power cycle
the DUT
Next!