Quick Start Guide

37 882E Quick Start Guide - HDCP Compliance Testing with Encryption Status Tester (EST) - P/N 68-00210 Rev. B
2. Activate the HDMI-H interface on the output port as follows:
a. Press the Interface key. A listing of signal interfaces appears on the generator’s
display as shown below.
b. Choose the HDMI-H item by pressing the adjacent soft key. The interface is
activated and the display is shown below.
Alternatively, to activate the interface through the command line interface, enter the
following commands:
XVSI 4 // Activates the HDMI-H interface
ALLU // Applies the interface setting to the generator
3. Press the Interface key repeatedly until the following menu appears:
4. Choose the HDMI IN 1 by pressing the adjacent soft key.
5. For the 882E when using the EST, verify that the source is sending in video using the
timing measurement function of the analzyer. Refer to “Measuring timing of video
signal” on page 241 of the User Guide for information on running the timing test.
Verify that the source is outputting the 640x480p at 59.94/60Hz format (DMT0660):
6. If the 882 cannot detect the incoming video enter the following command to turn on the
EST:
QD:PROD:EST // Turns on the EST.
7. Press the Tools key and choose the Reports item by pressing the adjacent soft key.
The following is displayed on the generator’s LCD.
VGA
HDMI-D
CVBS
S-VIDEO
SDI
*
HDMI-H
VGA
HDMI-D
CVBS
S-VIDEO
SDI
*HDMI-H
HDMI IN 1
HDMI IN 2
*
EDID Packets
Misc HDCP