Quick Start Guide

7 882E Quick Start Guide - HDCP Compliance Testing with Encryption Status Tester (EST) - P/N 68-00210 Rev. B
Running HDCP compliance test on HDMI transmitters
To run the 1A and 1B series HDCP compliance tests on an HDMI source (transmitter):
Note: The 1A-08 test requires that you use the SRM disc for the 1A-08 test if the source
device has an optical drive. Refer to “To run the 1A-08 HDCP compliance test using the
SRM disc:” on page 13.
1. Connect the cables as follows:
a. Apply power to the Encryption Status Tester (EST) using the power adapter
supplied with the EST.
b. Connect an HDMI cable from the source device under test output to the EST HDMI
port labeled, “HDMI IN.”
c. Connect an HDMI cable from the 882 HDMI Rx 1 port to the EST HDMI port labeled
“HDMI OUT.”
d. Connect an HDMI cable from the 882 HDMI Tx 2 port to the EST HDMI port labeled
“HDMI.”
e. Connect an HDMI cable from the 882 HDMI Tx 1 port to the HDMI input of the
display device (used to monitor the video).
The following diagram depicts the test setup for the 882EA: