User Manual

8. Radio set up
Press the RADIO soft key to enter the radio set up menu. To exit the
set up menu press the MODE/OK or SET buttons.
Radio modes
OFF
Radio “off”(no signal sent).
SYNC
Trio sends a sync only signal to remotes.
A
remote flash can be another Trio, any Qflash using an FW7Q, FW8R,
FW10w or any studio strobe using an FW8R, FW10w.
RX
A
remote Trio will fire when local flash sends a sync signal. Local flash can
also control exposure of Trio set to RX.
Local flash can be a Trio, a Qflash 5d-R using an FW9T or FW10w, or a QTTL
adapter with an FW9T.
LINK / QTTL
Trio will send a sync signal plus exposure control signals to remotes.
A remote flash can be another Trio or Qflash 5d-R using an FW7Q,
FW8R or FW10w. Rx will appear in upper left corner of display of the Trio.
8.1 Using Zones
Zones can be used to control individual remote units within a channel
group. Set each of the remote units to a different zone. For example :
room lights on Zone 1, an assistant with a light pole on zone 2,
background light on zone 3.
You can prevent any of the remotes from firing by simply turning that
zone off on the local Trio at the camera.
15
MODE
/OK
SET
CH. 4
ZONES
RADIO OFF
OFF
SYNC
RX
LINK
OFF
Channel Codes
The Channel Codes allow the Trio to work
together with FreeXWires and other Trios.
Set all units that you want to work together
to the same Channel Code. If you desire
independent groups (to work in the same
area but not interfere), assign each group
it’s own Channel Code.
ZONES
Zones can be used to control
individual units within a
Channel Code group.
+
-