User Manual

14. M Manual Mode Operation

14.1 On camera Manual Mode

F/number, ISO are sent to the

flash from the camera. Only the

power setting is user adjustable.

Press the Set button to highlight

the power setting. Use the

Left (-) Å and Right (+) Æ

arrow buttons to adjust the

power down or up.

Power settings are adjustable in

1/3 steps from full power to 1/32

power like this: 1/1, 1/1-, 1/2+, 1/2,

1/2- …… 1/32.

The distance in the display shows the correct subject to camera distance

for proper exposure. (Provided the correct reflector is set in the Options.

See section 9.5)

Using the Radio

The internal radio can be used to trigger remote flashes, or room lights,

set radio to SYNC.

Or the radio can be used to control the light output of remote Qflashes,

set radio to LINK. The remote flash can be another Trio in RL mode or a

Qflash model 5d-R set to Linked to Local with an FW7Q, FW8R, or

FW10w.

Be sure that the channel and zones match the channel and zones set on

the Trio. See section 8.0 for setting the Channel and Zones on the Trio

14.2 Off camera Manual Mode

For the off-camera operation Power, F/number, ISO are all user

adjustable. Pressing the Set button will highlight them in that order. Use

the left Å and right Æ arrow buttons to adjust the highlighted setting up

or down.

Using the Radio

To enable the Trio to be fired remotely set the internal radio to RX. A

FW9T or FW10w must be located at the camera position, or you can use

another Trio at the camera position.

Be sure that the channel and zones match the channel and zones set on

the Trio. See section 8.0 for setting the channel and zones on the Trio

MODE

SET

MAN 1/8 GN 55

F 5.6

7.7 FT ISO 200

FIRE OPT SAVE RADIO