User Manual

7.7 RA Remote Auto

Light output is controlled by the sensor located on the front of the remote

Qflash. F number and ISO information are sent to the flash from the

camera.

Use this mode if you want a remote flash to have the dedication of a TTL

flash, but the simplicity of the automatic sensor.

Radio: Defaults to receive (RX) mode.

Benefits : No pre flash required. Very quick mode. No time delay

between shutter and flash. Sensor limit available.

Note : Since exposure is controlled by the sensor on flash, user needs

to be mindful of camera placement. If the camera and flash are in widely

different locations, the picture may not be properly exposed.

7.8 RG Remote Group

Allows full control of remote Qflashes whose mode is set on the control

panel located on the local Qflash Trio.

Use this mode if you plan on making frequent changes to the settings on

the remote flash, such as mode, f number, and power

Radio: Defaults to receive (RX) mode.

Benefits : Greatest flexibility in flash set up without leaving camera

position.. Multiple flashes in mixed modes possible.

Note : Slower response, not good for action shots.

7.9 AM Advanced Multi

This mode allows the user to have full control over three remote Qflash

groups. There is no limit to how many flashes can be set to any one

group. Mode, F number, power, and even linking the exposure of a

remote flash group can all be set from the push buttons on the local

flash.

Radio: Defaults to QTTL mode. TTL ratio information will be sent to the

remote Qflash / Trio.

Benefits : Possible to set up mixed mode lighting set ups and make

changes without walking over to the remotes. Good mode to use if the

remotes are inaccessible.

Note : Slow to use, not good for action shots.