User Manual

16. RA Remote Auto Wireless Mode Operation
Exposure is controlled by the
sensor located on the front of
the remote. F/number and ISO
are sent from the camera or
local Qflash to the remote Trio.
Using the Radio
The radio will default to receive (Rx) mode. You may still need to select
the proper Channel to match the Channel on the Local Qflashes. See
section 8.0 for setting the Channel and Zones on the Trio.
The Local flash may be :
1. A Trio in any mode, the radio of the local Trio must be set to LINK or
QTTL.
2. A Qflash 5d-R in any mode with an FW9T or FW10w. The TTL
feature / switch must be turned on, see your FW instructions for turning
the TTL feature on.
3. A QTTL adapter with an FW9T, with the TTL switch turned on
16.1 Remote Auto Wireless soft keys
To change the function of the soft keys use the Left (-) Å and Right (+)
Æ buttons when no selection or setting is highlighted on the display.
The default, radio zones and sensor limit soft key functions are available.
16.2 Remote Auto Wireless exposure indicators and Sensor Limit
The exposure indicators and Sensor Limit function the same as they do
in Auto mode. See section 11.4
30
MODE
/
OK
SET
REMOTE AUTO W
F 5.6
7
2.4 –22 FT ISO 200
FIRE OPT SAVE RADIO
FIRE OPT SAVE RADIO 1 ON 2 ON 3 OFF 4 OFF
(
DEFAULT
)
(
RADIO ZONES
)
5 10 15
–
20
(
SENSOR LIMIT
)
+
-
RA