User Manual

3.0 Mounting & Power Accessories
3.1 Mounting
QF29 – for under camera mounting OM42 – for twin rail mounting
3.2 Power
AC Power – OM44 (provided)
DC Power
V Mount Battery – using OM41 power cable
Quantum QB8, T3 – using OM43 power cable
4.0 Operation
4.1 Connections
4.2 ON / OFF
4.3 Adjust Light Intensity (0 – 100%)
Push and release the Mode knob, the display shows the intensity 0 – 100%.
On
Press and hold the Power
button until the digital display
shows “ON”. The OM4 light
output will gradually increase
to the last intensity setting
used. The intensity level (0 –
100) will appear on the
display.
Off
Press and hold the Power
button until the digital display
shows “OFF”. The OM4 light
will gradually dim.
Connect a power
source to the Omicron
4. See Section 3.2 for
a list of power sources.
The digital display shows
“rdY” and will blink once per
second. The OM4 is ready to
operate.
If the digital display blinks “Lb”.
It indicates the voltage of the
power source is too low to
operate. Check the battery
pack operation.
The battery may need charging
75
Adjust the light intensity
Turn the Mode knob
clockwise to increase the
light intensity, count-
clockwise to decrease the
light intensity.
Power button
Mode Knob